How do I

Steve Brown · Post by **Steve Brown** » 15 Jun 2022 10:35

Get the cam drive and primary pinions off the crank of my Corsaro 125? Anyone know if there is a special puller etc?

Steve Brown · Post by **Steve Brown** » 15 Jun 2022 20:09

Question now answered by Jenny Westwood-thanks Jenny! I need a better puller so shopping I will go. Finally lost patience with the cement dust/oil concrete like covering of everything on this bike and stripped the chassis down today as well. Even after scraping and washing there is still clag sticking to it in hard to reach places. It's everywhere! Either the previous owner lived in a quarry or a bunch of kids used it as a field bike at the end of its first life. This is getting dangerously close to a trip to a blaster and then a decision on paint or powder.

I didn't want to go there but may have to in the end. The quick fix/oily rag plans are long gone now. I do have a reg number for it now though, which is nice!

Daddy Dom · Post by **Daddy Dom** » 15 Jun 2022 20:55

Excellent, I can see you're fixed now but I was going to suggest you try and source a Clag-Gone tool that was once advertised in Viz Comic.
DD

Steve Brown · Post by **Steve Brown** » 15 Jun 2022 22:10

Daddy Dom wrote: ↑15 Jun 2022 20:55 Excellent, I can see you're fixed now but I was going to suggest you try and source a Clag-Gone tool that was once advertised in Viz Comic.
DD

Brilliant! I'll check my collection of back issues!

Godden 89 · Post by **Godden 89** » 25 Aug 2023 12:45

Due to the unavailability of the Clag-Gone tool I now use a wire brush!

MRC Forum- brought to you by www.morini-riders-club.com

How do I

How do I

Re: How do I

Re: How do I

Re: How do I

Re: How do I