On my trip to the SRS the plug on the front down pipe parted company on the M90. A trip to Halfrauds and a piece of aluminium and a jubilee clip fixed the blowing. I have been trying to figure out the thread and took out the rear one. After a bit of measuring and a trawl through t'interweb I bought a brass replacement.
Thread is, wait for it, 1/8" BSP... Easily obtained as used on lots of things...
I'll buy a few as spares!
Imperial Milano
-
- Posts: 2465
- Joined: 22 Nov 2008 17:41
- Location: Even further oop North
Re: Imperial Milano
Bet you never expected to be nipping out to the "Plumb Centre" for Morini spares.
-
- Posts: 2465
- Joined: 22 Nov 2008 17:41
- Location: Even further oop North
Re: Imperial Milano
No! Apparently the Italians use the 1/8" bsp in toilet cisterns!
No more comments, please!
No more comments, please!
Re: Imperial Milano
Serious comment Mike, if its the same as mine, if you mean the one in the front pipe right at the bottom, has drillings for lockwire, not sure what one could wire it too though.
Cheers Mark
Cheers Mark
-
- Posts: 2465
- Joined: 22 Nov 2008 17:41
- Location: Even further oop North
Re: Imperial Milano
Mine didn't! you could tie it to the lambda sensor.