Welcome new forum members - introduce yourself
Re: Welcome new forum members - introduce yourself
It would be good to meet up with yourself and MM once the weather improves. I intend putting the threeanarf on the road at the beginning of April. Hopefully the salt will have gone by then and Mrs GB will have got back into the swing of riding again after many years off it. The Morini was bought for her as its small enough for her to reach the ground
I was at Fimber yesteday. Sunny and dry but bitterly cold even with the benefit of a R100RT fairing and a pair of horizontal boot warmers. We didnt sit around for too long
I doubt if anyone will be there tomorrow given the forecast!
Steve
PS regularly riding an assortment of old Brit iron, a left gear change is the one I have to think about most. How Ill get on with the Morinis up for up shift remains to be seen - and there's 6 of the buggers to cope with
I was at Fimber yesteday. Sunny and dry but bitterly cold even with the benefit of a R100RT fairing and a pair of horizontal boot warmers. We didnt sit around for too long
I doubt if anyone will be there tomorrow given the forecast!
Steve
PS regularly riding an assortment of old Brit iron, a left gear change is the one I have to think about most. How Ill get on with the Morinis up for up shift remains to be seen - and there's 6 of the buggers to cope with
-
- Posts: 2468
- Joined: 22 Nov 2008 17:41
- Location: Even further oop North
Re: Welcome new forum members - introduce yourself
I'll arrange a meet up in April. Watch Morini Events for details...
-
- Posts: 61
- Joined: 13 Jun 2019 21:00
- Location: Cobham, Surrey, UK
- Location: Cobham, Surrey, UK
Re: Welcome new forum members - introduce yourself
Just a quick introduction. I have just bought a 1978 350 Sport that may well have been a Strada. She has spent a few years off road and I am working my way through recommissioning. Carbs have been stripped, ultrasonically cleaned and reassembled with new o-rings and gaskets. That got her running, if somewhat roughly, new battery and dual cable throttle to be added next. Then I'll be trying to balance the carbs.
I am 54 year old Vicar, returning to bikes after selling my Triumph Daytona 675 in 2011 while living in the USA. I live in Cobham, Surrey. Any other members nearby?
Mike
I am 54 year old Vicar, returning to bikes after selling my Triumph Daytona 675 in 2011 while living in the USA. I live in Cobham, Surrey. Any other members nearby?
Mike
Re: Welcome new forum members - introduce yourself
Hi Mike
Welcome to the forum and to Morini ownership!
There are a number of Morini Riders Club members in the Reading area, and one long standing member in West Surrey.
There's a club meet of the Corsaro section (all Morinis welcome) as well down near Alton.
Original Sport engines had 'S' stamped on the crankcases at the base of the front cylinder barrel on the right hand side,
but it doesn't really matter so long as it runs well and gets used!
Mark
Welcome to the forum and to Morini ownership!
There are a number of Morini Riders Club members in the Reading area, and one long standing member in West Surrey.
There's a club meet of the Corsaro section (all Morinis welcome) as well down near Alton.
Original Sport engines had 'S' stamped on the crankcases at the base of the front cylinder barrel on the right hand side,
but it doesn't really matter so long as it runs well and gets used!
Mark
-
- Posts: 941
- Joined: 05 May 2006 13:47
- Location: Northampton
Re: Welcome new forum members - introduce yourself
Welcome to the club and to the forum Mike!
There are quite a few morini club members in the south east. On the website is a map showing approximate locations of all our UK members- so you can see how many are nearby!
Because of data protection we can’t share member contact details but we can help to put you in touch with local members if you need.
The interactive member map is at the bottom of the below page
http://www.morini-riders-club.com/theclub/MRC.html
Or below is a quick image of the southeast so you can see without even having to leave the forum!
There are quite a few morini club members in the south east. On the website is a map showing approximate locations of all our UK members- so you can see how many are nearby!
Because of data protection we can’t share member contact details but we can help to put you in touch with local members if you need.
The interactive member map is at the bottom of the below page
http://www.morini-riders-club.com/theclub/MRC.html
Or below is a quick image of the southeast so you can see without even having to leave the forum!
- Attachments
-
- 03D4A208-AE98-419E-BF2D-D05E5B810B2D.png (1.95 MiB) Viewed 13293 times
Re: Welcome new forum members - introduce yourself
Welcome Mike. When you're recomissioning the bike, don't forget to replace the cambelt - it's only a 20 minute job.
"I'll have a V please, Bob."
-
- Posts: 25
- Joined: 23 Sep 2019 12:49
- Location: Cambridge
Re: Welcome new forum members - introduce yourself
Hi All
Barry here in Cambridge. I'm a long-term Guzzi owner but a 1981 Morini 250 which I know little about has come into my possession! It's in good condition and just a few little jobs need doing to bring it up to standard. It's got the look of a bike that's always been looked after, which make a pleasant change. It's got a pretty mediocre seat cover I'd like to replace, so I'm hoping these are the same size as the 350?
I wasn't keen on the fairing and the lower panels were kind of hiding the nice looking engine, so they have come off.
Barry
Barry here in Cambridge. I'm a long-term Guzzi owner but a 1981 Morini 250 which I know little about has come into my possession! It's in good condition and just a few little jobs need doing to bring it up to standard. It's got the look of a bike that's always been looked after, which make a pleasant change. It's got a pretty mediocre seat cover I'd like to replace, so I'm hoping these are the same size as the 350?
I wasn't keen on the fairing and the lower panels were kind of hiding the nice looking engine, so they have come off.
Barry
-
- Posts: 321
- Joined: 11 Sep 2012 13:49
- Location: buxted east sussex
- Location: Uckfield, East Sussex.
- Contact:
Re: Welcome new forum members - introduce yourself
Hello Barry, welcome to the world of Morini’s. Nice looking bike, I cannot help much about the seat as I have no knowledge of the 250 bikes, do like the look of them.
Regards Pete.
Regards Pete.
Re: Welcome new forum members - introduce yourself
Hi Barry
Welcome to the forum. Nice looking bike. Can you tell me anything about the 'prop' stand - I'd like to get one for my 250 single? Maybe post a close-up picture?
Dave
Welcome to the forum. Nice looking bike. Can you tell me anything about the 'prop' stand - I'd like to get one for my 250 single? Maybe post a close-up picture?
Dave
-
- Posts: 2468
- Joined: 22 Nov 2008 17:41
- Location: Even further oop North
Re: Welcome new forum members - introduce yourself
That's not a side stand, that's an RSJ! Looking for the fabricators having their lunch sitting on it!
Re: Welcome new forum members - introduce yourself
Welcome to the forum. I have a 250 too, though it's still 'under reconstruction'. The seat, like the rest of the bike, was a little worn, so I used a seat cover from Aliexpress, less than a fiver all in I now have one on nearly all my bikes. Like this https://www.aliexpress.com/item/4000124 ... b201603_52
On the question of the sidestand, I've made one from a modified moped sidestand which attaches to the silencer fixing points. Like this https://www.la-becanerie.com/cyclo/part ... omee1.html
On the question of the sidestand, I've made one from a modified moped sidestand which attaches to the silencer fixing points. Like this https://www.la-becanerie.com/cyclo/part ... omee1.html
Re: Welcome new forum members - introduce yourself
Welcome (from a relative newby myself). Don't the 250s have any sidestand option as standard? That is a beast though!
-
- Posts: 25
- Joined: 23 Sep 2019 12:49
- Location: Cambridge
Re: Welcome new forum members - introduce yourself
I didn't take much notice of the side stand, but I'm not sure it's staying on. The Bike is at a friends at the moment, so I'll get some proper photos when I go over. The previous owner was in his 70s, so it could have been added when the centre stand became a bit much. I don't know if they had one as standard?? This looks to have been engineered as a one off, but it's quite a piece of work!
I was hoping to get a more original seat cover, which is why I was wondering if the 350 is the same size.
Taking the fairing off meant it lost the front indicators, but I've managed to source these. It also threw up a slight problem in that the master cylinder didn't have a mount for the wing mirror. It was a Grimeca with an oblong reserviour but I wonder if it was for a trials machine. A replacement is on its way with a round top. The wiring isn't bad, but needs a bit of a tidy up. Other than that, just a really good engine service needed and it looks as though Mdina Italia is the place to go for gaskets, timing belt etc.
It needs a set of tyres. A search here seems to suggest Avon RoadRiders, or Bridgestone BT45.
Barry
I was hoping to get a more original seat cover, which is why I was wondering if the 350 is the same size.
Taking the fairing off meant it lost the front indicators, but I've managed to source these. It also threw up a slight problem in that the master cylinder didn't have a mount for the wing mirror. It was a Grimeca with an oblong reserviour but I wonder if it was for a trials machine. A replacement is on its way with a round top. The wiring isn't bad, but needs a bit of a tidy up. Other than that, just a really good engine service needed and it looks as though Mdina Italia is the place to go for gaskets, timing belt etc.
It needs a set of tyres. A search here seems to suggest Avon RoadRiders, or Bridgestone BT45.
Barry
Re: Welcome new forum members - introduce yourself
Timing belts are freely available (and much cheaper) from your local bearing factor, or the internet.
Re: Welcome new forum members - introduce yourself
If you end up with the stand surplus to requirements, I would be interested in buying it.