Page 1 of 1

Project Kanguro Supermoto - Phase 3 sheetmetal

Posted: 18 Jan 2007 21:43
by robinh44
Hi,

Well up from late summer to autumn not to much done, then over winter started on the rear end. Finally attacked the 2 large sheets of perforated stainless steel I had bought and managed to man handle it into some side panels and the tail fairing. Finished reshaping the BMW seat and with the assistance of my local shoe repairers ( who stitched and glued 3 pieces of leather into 1) I now have a nicely upholstered ex-BMW seat. Next will be some blending work on the tank-seat area and the construction of a battery/electrics box to go under the tank. Current picture below:-

Image

Regards

Robin