MRC Forum- brought to you by www.morini-riders-club.com

It's taken ages to sort out the discs on the 500 and I've made the rookie mistake of not recording image sof where the 2 washers you can see on the axle go and now I've forgotten

It would be really handy if anyone could tell me and save me a heap of experimenting!

Thank you

These images show a bit clearer the items that Id like to check where they go on the axle please!

Try the 500 parts book for an exploded diagram - there should be one in the library

The washers go under the nut on the left side and the outer end of the long through spindle on the right/drive side

Cheers, and does it matter which way round the spacer goes?

Tim

Tim wrote: ↑22 Jun 2025 09:26 Try the 500 parts book for an exploded diagram - there should be one in the library

Cheers, Ive got that but it's not entirely clear

'Cheers, and does it matter which way round the spacer goes?'

Yes, the smaller diameter end fits in the bearing oil seal - note there is no oil seal fitted in your photo

Oh dammit I suspect I've got a missing part then - any ideas where i could get one of those oil seals from?!

Oh dammit I suspect I've got a missing part then - any ideas where i could get one of those oil seals from?!

The parts list will tell you the sizes usually and any bearing stockists should have them. All common sizes.

I have got a parts list I'll have a look cheers

'It must be a .....' wrote: ↑22 Jun 2025 15:48 'Cheers, and does it matter which way round the spacer goes?'

Yes, the smaller diameter end fits in the bearing oil seal - note there is no oil seal fitted in your photo

hAVING LOOKED AT THE PARTS DIAGRAM it looks like there's already a seal on the inside of the circlip and it doesn't show another one?