Mixture screw
Posted: 19 Nov 2014 18:17
Hi.
my Morini is being delivered tomorrow evening, so to amuse myself I've been putting together a sort of to-do list as it hasn't been on the road for a number of years.
I'm going to start with an oil and belt change, a thorough clean/check of the carbs, set valve clearances and check the timing.
My question is this - does anyone know the base setting for the idle mixture screw.
I've looked in the manual and done a search on the forum but I couldn't find anything, or perhaps I couldn't see the wood for the trees!
From experience of other Dell 'Orto equipped bikes/scooters I was thinking 1 to 1.5 turns from a light seating.
Am I near?
Thanks.
my Morini is being delivered tomorrow evening, so to amuse myself I've been putting together a sort of to-do list as it hasn't been on the road for a number of years.
I'm going to start with an oil and belt change, a thorough clean/check of the carbs, set valve clearances and check the timing.
My question is this - does anyone know the base setting for the idle mixture screw.
I've looked in the manual and done a search on the forum but I couldn't find anything, or perhaps I couldn't see the wood for the trees!
From experience of other Dell 'Orto equipped bikes/scooters I was thinking 1 to 1.5 turns from a light seating.
Am I near?
Thanks.
