MRC Forum- brought to you by www.morini-riders-club.com

Looking for a drawing for the large and small stator bobbins for 350-500 Morini alternator , it will saving me having to draw them out, as looking to getting some 3D printed in ABS.

Cheers
Stempy

Hi,
While I can't help re bobbins, I have to ask, how many laminations do you need them for?

Machined flywheel type have less than cast flywheel/electric start ones, ie the metal bit is thinner on the earlier ones.

Good idea you have there though. I'm sure there will be others very interested if you can get them done.

Regards,
George