MRC Forum- brought to you by www.morini-riders-club.com

350 rectangular warning lights and bulb holders required

Cheers
Stempy

I doubt there are that many left.

The bulb holder is readily available its a T5 286 wedge (though not cheap) and standard on various Land Rover models

try classic car leds

T5 74 286 VDO TVR LANDROVER DASH GAUGE BULB HOLDER YAJ100390 N05-800-218

nice and bright - may be too bright for some (resistor needed to dim them) when paired with correct coloured LEDS, which are way more reliable than the filament bulbs. Fitted on all mine.

Mark

I 3D printed some rectangular warning lights when I first started using my 3D setup for practice - they turned out pretty good! Trouble is they are orange as that was the free filament with the printer!! I also got some translucent lenses printed - red, orange and green (well it's a greeny yellow but that was the darkest they had!!).

If you want to give them a go (I'll do them in black!) let me know. Apart from that they aren't as scarce as the early ones so keep hunting!

John.

John
Pm sent

I'm considering filing these down to make new lenses, good colour
https://www.ebay.co.uk/itm/124064866753 ... media=COPY

What about these to file down?

https://www.ebay.co.uk/itm/282586401054 ... R9jyzKzqYQ

nice one