MRC Forum- brought to you by www.morini-riders-club.com Member: g7AW3f

Does anyone have any spare tools as follows:

001 Clutch holder

003 Primary drive pinion holder
004 Primary drive locking ringnut remover
005 Camshaft pulley tool
006 Flywheel holder

Alternatively, do you have drawings of those tools so I can make them up? I see that there is a drawing of special tool 006 on this page so I am looking for similar drawings of the other tools.

These are for working on my 500, if that makes any difference. I think I can either borrow or improvise for most of them, but would prefer to have my own set of tools available.

Thanks

for a flywheel holder I use a strap wrench bought for £9.99 from a DIY store.
Talk to NLM for other tools; the MRC has given up its tool hire scheme because NLM's prices are not bad. Occasionally tools turn up on Ebay but the price is no cheaper than NLM's.
There are US websites that sell adjustable peg spanners that would suit the primary drive gear and camshaft pulley holders but they're expensive & you'll pay to import.
There used to be an Australian site which gave dimensions for all the tools but a quick search failed to find it.
Good luck!