Page 1 of 1
Excaliburbrake wanted
Posted: 04 Dec 2010 11:43
by hombre
Hi All,
Anyone here who has a frontbrake caliper for a 501 Excalibur?
Something like this
The distance between the holes measured from the centre is 9.5 cm (don't know the inches)
tia,
Hans
Re: Excaliburbrake wanted
Posted: 10 Dec 2010 19:22
by andyroach
Hi Hans,
I think I have one of these in my bike shed. I have the remains of a Newyork and a couple of kangaroos. I will have a look in the morning.
Cheers
Andy
Re: Excaliburbrake wanted
Posted: 11 Dec 2010 11:36
by hombre
Hi Andy, found anything? I believe the caliper I am looking for is only used on the last series Excalibur...
Re: Excaliburbrake wanted
Posted: 12 Dec 2010 12:07
by andyroach
Hi Hans,
I have foundthe caliper, but the mounting holes are 102mm +/- centre to centre. But 95mm if you measure from the inside of each bolt. I am not sure which model this caliper came from as it was loose in a box with lots of other bits from a Kangaroo and an excalbur/new york. It looks identical to yours.
My personal email is :
andyroach@yahoo.com. Email me there and I will send you some pictures.
Andy