Kanguro - Front Cylinder Push Rod

[jb666]

The nice shiny bits to resurrect the Kanguro arrived from NLM but they didn't have any front cylinder push rods. Anyone got one available?

[hombre]

They are probably the same as in all 350's (someone correct me if I'm wrong).
I have one for you...

[norbert]

They are the same in all 350 motors, with the dirference that in the early motors they were 7mm, later 8 mm turned down to 7 mm at the ends to fit the steel endings. The old ones were 5 gr. lighter 30 in spite of 35 gr. (the main reason to me apears to be the smaller iron part at the upper end)

k-DSCI0183.JPG (36.99 KiB) Viewed 6326 times

The rear pushrods are about 2 mm longer. The sizes over all front/rear:

500 und 250T: 205/207 (therefore the 250T should be 205)
501: 202/204
350: 182/184

ciao
norbert

[hombre]

I have these, they vary a bit in lenght but should all come from 350-engines