plain bearing

[mad muller]

this is a long story, so i wont tell it here! has anyone got standard plain bearing for later sport engine it has 3 allen bolts holding bearing houseing into the crankcase, good used might do in or out of its housing, if you have done the main conversion , maybe you kept old bits if useable let us know. thanks. ps i know nlm have them but as i said its a silly one.

[buell1203]

Paul.


Any reasonable engineer could make the plain bearing very easily. phoshor bronze is expensive though, and making a bearing loses most of the material you have bought. I could do it for you but time is short and I do not get my own things done nowadays. Hope you get sorted soon. John

[mad muller]

thanks for offer buell, keeping open mind what to do , see what turns up , did fit new one standard size , but worse fit than one that came out , the crank has not been reground, thanks again , muller.