Plastic Instrument Surrounds

[Stunty69]

Hi, does anyone know if i can get new ones of these? The circular black plastic surrounds, that have those "oh so strong" 3 little fixing lugs that seemed to snap like dry twigs when i went to remove them! I need two! (and the horrid metal clips that hold them in place).
Thanks...

[EVguru]

There are stainless replacements.

[Stunty69]

Sorry, not the metal plate, but the plastic circular 'cowls' almost, that go over the clocks, and are secured on the mounting plate by three plastic lugs....

[EVguru]

There are stainless replacements!



These from http://www.morinibadges.com/products.html

Oh and you might have heard of North Leicester Motorcycles?

The rumor is they do one or two Morini bits

[Stunty69]

Ahhh stainless replacements.... lol sorry, i thought you mis-understood.
Thanks, look nice but would prefer to keep the bike looking as 'original' as poss, have emailed stuart at NLM, but he normally takes ages to respond!

[atreyu]

NLM also do plain steel ones..... Paint em black?

[George 350]

Hi,

Unless you are really wanting/doing a 100% concours, then If you still have the original rings, drill a dia 2.5mm hole approx 6mm deep where the snap off peg(s) used to be and use an M3x8 screw/washer to retain the rings. No need to tap a thread, the screw will do it. Looks way neater and is easier to clean this area as the cleaning cloths have nothing to snag on.

Hope that this helps,

George.