Main and big-end bearings

[mbmm350s]

resurrecting an old thread.

I measured a plain bearing journal on an 80K miles 350 A engine as 46.28 , and the standard size is 46.355?

Mdina part lists 25.03.20 shell mains brg oversize i/d 45.9mm
but that's -0,45 (approx)
Is there no longer -0.2 option? part number 25.03.20 is supposed to be -0.2mm
And this is the complete assembly?
Thanks
Mark

[MickeyMoto]

hello Mark,

When I did my crank only the second undersize was available.

Mike

[harrymuffin]

Not wishing to be pedantic, but don't you mean undersize?

[mbmm350s]

Thanks Mike.
Quality? Good, OK or bad?
Are they split like the original?

Harry:

Mdina part lists 25.03.20 shell mains brg oversize i/d 45.9mm

I just quoted from Mdina website.
Mark