Torque settings

[wingnut]

Hi

I am doing a light overhaul of my engine (1981, 350 K1) before slotting it back in my frame, does anyone know the correct torque settings for the Front sprocket, generator/flywheel and the cylinder head nuts. any advice gratefully recieved.

Thanks

[MarcoPau]

Heads: 2 mkg (2,7 for a half our then going back to 2,0 if you fit new gaskets)
flywheel: 6,5 mkg
rocker arm brackets: 1,3 mkg

Don't know about the sprocket, I use a power wrench.

[wingnut]

Thanks for that, I will get everything sorted today.

[3potjohn]

I have found the front sprocket can get loose on the shaft, which cannot be a good thing. I think it should have a spring washer under the nut,perhaps someone will confirm.

[wingnut]

When I took my old sprocket off it was held on by a spring washer and a nylok nut, judging by the state of the bike I think that these are probably original.

[j2maria]

Does anyone know the torque settings for the engine mounting bolts and the swingarm pivot nuts? I've searched the forum and the blue book to no avail.