Re: Sprockets wanted
Posted: 16 Dec 2020 18:41
B&C arent cheap, but they are very good
Hi Dave,buzby wrote: ↑13 Dec 2020 11:18 This is the description on my invoice "Renthal Rear Sprocket Blank 38mm Tooling Hole (100--520-40FS)" and the cost was £51.16 including P& P, so not cheap but it fits perfectly and looks good quality.
I phoned B & C and they were very helpful and they said they had the pattern for this Morini hub so no problem and I can recommend them.
I had a new DID chain on the shelf already, left over from some other project, so I can't say how much that would cost.
Dave.
Did it work out Ok? Will be going down the same route on another 2C
Cheers
Mark