I notice in the parts book there is a plastic ring that fits at the engine end of the inlet rubber, No 26:
I haven't been using them, so got a pair from Mdina:
My 2 questions are
1) Are they needed?
2) The pair I have bought seem a little longer than where they fit, is this correct, or does their length need shortening a bit?
0Inlet rubber "Ring" 32.01.32
- Parker3865
- Posts: 126
- Joined: 13 Sep 2022 18:16
- Location: Brentwood
- Contact:
Inlet rubber "Ring" 32.01.32
Morini 250 2c rebuilt from a box of bits.
Re: Inlet rubber "Ring" 32.01.32
They are just to proyecto the rubbers because the clamps may hurt them. I use them on both ends of te inlet rubbers