MRC Forum- brought to you by www.morini-riders-club.com

Posted: **09 Feb 2024 12:41**

Ahhhhhhh....the manual is actually 5.5MB so should be e mailable.

Send request for one by e mail to arthurwfarrow@hotmail.com

Posted: **10 Feb 2024 20:48**

Thanks mate I’ll be in touch

Posted: **09 Apr 2024 10:46**

Just a little update, wheels not fully stripped and we’ve started to plate some of the parts.

I’ll be sure to pop some more pics up soon.

Posted: **09 Apr 2024 12:29**

Oh that looks posh

I would have masked off the spindle areas where they cannot be seen/go through bearings to ensure you do not get minor interference.

Posted: **09 Apr 2024 14:46**

Let’s hope they still fit.

Thanks Kris

Posted: **09 Apr 2024 15:35**

Oh they will fit 100%

Only nickel plated them for 45 mins so not too many microns on them.
Little tickle on the lathe with some emery if needed

Posted: **09 Apr 2024 21:27**

Ok test for amount of nickel plating time so as not to cause an issue with the nipple threads being too tight on the spokes.

A 40 min plate for both spoke and nipple @ 700ma. All was good

: IMG_1388.JPG (417.1 KiB) Viewed 1210 times

: IMG_1395.JPG (318.63 KiB) Viewed 1210 times

: IMG_1389.JPG (443.74 KiB) Viewed 1210 times

Posted: **09 Apr 2024 21:29**

: IMG_1394.JPG (343.44 KiB) Viewed 1210 times

Posted: **10 Apr 2024 06:25**

Good work Dave

MRC Forum- brought to you by www.morini-riders-club.com

125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T

Re: 125 2T