Won’t fire up after valve check
Posted: 25 Jan 2024 02:32
Hi. Just wondering if someone could give me a lead. I have just finished checking the valve clearances which I was happy they were still in tolerance after 26000 kilos if on the minimum. I decided to leave as is but check a little sooner down the track.
To do the job I removed the air box with throttle bodies etc which made checking the clearances easier.
This Morning I put everything back after also changing the fuel filter.
On turning the key it goes through all the normal electrical starting procedure then when I hit the starter the motor does 3 or 4 normal sounding engine turns then stops.
I have checked over all my connections.
What would allow it turn over a set amount of turns then stop?
Interested in your advice.
Cheers John
To do the job I removed the air box with throttle bodies etc which made checking the clearances easier.
This Morning I put everything back after also changing the fuel filter.
On turning the key it goes through all the normal electrical starting procedure then when I hit the starter the motor does 3 or 4 normal sounding engine turns then stops.
I have checked over all my connections.
What would allow it turn over a set amount of turns then stop?
Interested in your advice.
Cheers John