MRC Forum- brought to you by www.morini-riders-club.com

I know this is a long shot, but does anyone have a spare R/H footrest hanger for sale, I have a bent one.
Thanks in advance

645 views and nearly 2 months, and not a single comment!

Perhaps 646 people do not have a right foot peg!

Can you not bend it back?

Tinker wrote: ↑23 Jun 2024 08:15 Can you not bend it back?

Original is sorted 95% back to straight now it was quite difficult as the previous Aerospace engineering owner had drilled them with a home made drill made out of concrete and straw, and had managed to drill though some of the webbing on the rear. When I removed the hanger, there was an attempt by a blind monkey to inset a helicoil in the large hole. It was a good job I had to remove it because of my incident as there was quite a pronounced fracture crack from the webbing , starting from the Helcoil sticking out the back.

MickeyMoto wrote: ↑22 Jun 2024 21:00 Perhaps 646 people do not have a right foot peg!

Yes I get that, but I was hoping that someone might have been able to point me in the direction for a source of a used or new one.

Yes, but if anybody did have that information they would have told you.

I always take a no response as a no or somebody doesn't want to tell me.

If you have tried Mdina and eBay and now the chap who bought the Barcelona horde then the likelihood is that one is not available. Always possible with a 20 year old bike, many of which have slid down the road.

Good luck with finding one, if I come across one I'll let you know.

Can you find a friendly welder to sort the crack and weld up the hole to retap it

Tinker wrote: ↑24 Jun 2024 20:52 Can you find a friendly welder to sort the crack and weld up the hole to retap it

Already done. It doesnt need retapping, the holes should not have been there in the first place!

There are a couple of guys in Italy breaking Granpassos on the GranpassoEU page