MRC Forum- brought to you by www.morini-riders-club.com Member: g7AW3f

Hi,

I am a newclub member from France aswell a newcomer to the forum.
The Dart is not my Morini but I also deal as a link between your club and the French club Moto Morini Passion
Alain, the web site manager owns a Dart the fairing of which has now more than a lot of cracks and Alain minds to find a new one.
He has found some one made of GRP on the web site from HC Racetech, a company based in Lincoln and managed by some Dave Cooper.
Has anybody here heard about this company and the products it offers?

Thank you for reply,

Au revoir,

François

A couple of years ago I sold a Freccia to a friend and he made a complete set of moulds. When I found out and saw the result, I asked him to make Dart front panels as they are the only ones that are different. Shortly after he'd done so, GRP panels showed up on ebay from HC Racetech. Coincidentally, both my friend Daz and HCR are from Lincolnshire.

I've not seen any HCR panels to comment on the quality. Most of the panels Daz made were very good, but the Dart panels I supplied for moulding were not the best. I sent a pair over with the Dart I sold Jarl to go land speed record chasing, so he'd be the best person to comment on their quality although I don't know how keen Daz would be to make more.

Hello FB21,

my name is Olaf from Germany.
I have moulds from all panel parts of the Dart.
If you need panels made with GFK, then send me an messeage
and I can make you a offer.
The quality of thes handmade panels is very good.
For information: The sidepanels of the freccia are not the same like theseone of the Dart!

Hi Olaf,
Already give a link of your website to François.

Thank you Olaf.
As explained I am notthe direct customer.
I had transmit the information to Alain.
But I may stay in the matter as the translater.

Keep you aware, thank you.

François