MRC Forum- brought to you by www.morini-riders-club.com Member: g7AW3f

Hi Arthur, any good? PM sent, Ian

Morini used both Tommaselli (Domino) and Verlicchi levers over the years Plus both fulcrum lengths were used but the shorter will be lighterr to pull and give a more progressive feel Getting the cable outer to inner lengths right and adjustment at the engine lever helps too Plus regular lubrication ...

Cymru/Wales Section meeting

Sunday 30th November 2025 from midday onwards at the usual venue

Erwood Station Craft Centre, LD2 3SJ nr Builth Wells

Hopefully by then it'll be dry

Meanwhile have some fun, Ian

Used on the CEV Road & Camel 500 6 contact ignition switch (both 12V & 6V DC circuits) Probably tha same on later Road 350s? OFF (centre) - 3 & 4 connected PILOT (anticlockwise) - 3 & 4, 1 & 6 connected ON (clockwise) - 1 & 2, 5 & 6 connected Wire colours to switch spade ...

Cymru/Wales Section meeting

Sunday 26th October 2025 from midday onwards

Erwood Station Craft Centre, LD2 3SJ nr Builth Wells

Hopefully it should be dry

See you Sunday, Ian

Which Camel? 500 Mk3/501 X2 or X3

Sorry no photos, this time but you've seen my Morini before!
No borders raid today, yet the usual support of interesting bikes/folks including two Morini owners.
Can't believe it's nearly October already, see you then? meanwhile have fun, Ian

Cymru/Wales Section meeting

Sunday 28th September 2025 from midday onwards

Erwood Station Craft Centre, LD2 3SJ nr Builth Wells

See you Sunday, Ian

Which Camel, 500 or 501? 501s have steel tanks but most 500s have fibreglass tanks, If so it could be an ethanol fuel issue with the slides becoming coated and sticky? First as you mentioned change/re-route the cables, fit newcarb rubbers/filters, tighten inlet spigot etc plus clean/service, tune an...

Erwood Station 30-8-25

Thanks Jen, the North Cotswolds section turned up even given the gloomy weather forecast. Great afternoon at Erwood Station with warm sunny weather etc Again well supported by the ever friendly Marches and Mid Wales groups with a lovely selection of bikes etc. Hopefully more Morini owners will be th...

Sunday 31st August 2025 from midday onwards

Erwood Station Craft Centre, LD2 3SJ nr Builth Wells

All welcome, see you Sunday, Ian

I also like the black/metal type but over the years I've had no problems with the white plastic version which have a metal tab for adjustment

Dim problem, Ian

It developed into a lovely day, but initially I got very wet on my way there from south west Wales
Great welcome, bikes, company, venue, food etc plus a sunny ride home on empty roads

Again a great turnout, especially from the Marches Section