MRC Forum- brought to you by www.morini-riders-club.com

Thanks all! The new smaller diameter one just makes me nervous. I would say my original just has a little scuffing on the tapered section. Really wrinkles where it looks compressed but it still pliable. I’m still pondering if to re-use. I may just clean up and throw some silicone grease on for good ...

Hi all, I am doing a clutch side tear down to sort a leaking clutch seal. My oil pump seal (green) looks a little worn too so I figure I’ll swap him out too. However when digging through my spare parts, my oil pump seal from mdina appears to be of tool small outside diameter to be a press fit within...

Hendre, thanks again. I should have rephrased my question, did you have any issues with the stock airbox connections?

70sbikes wrote: ↑30 Apr 2023 10:39 I used the centre column to work out the equivalent jetting for my Mikuni VM28's.

Great input, I think I saw your thread elsewhere. Mikunis we’re going to be my back up option as I would prefer to stay dellorto.

Hendre, thanks for the reply and confirmation. One thing I am not seeing on the euro carb website is the threaded intake in the PHBL 25s so I can transfer the current plastic “velocity stack” from the VHBZs…did you need to do this? Also what needle did you end up using? The on in the middle column a...

My main jet threading has stripped on my vhb and the whole thing seems like it’s getting a bit fragile/worn so I am looking for a more modern replacement.

I found this on another thread, with the center column as the recommendation. Can anyone confirm this is correct for the PHBL 25s?

Hello all,

Has anyone put dellorto PHBH 26s or PHBL carburetors on their 31/2 and if so what jetting worked for you? I want to use the stock airbox

Fiona, I did! Sorry for the late response, I was away without internet for a bit. Thanks for the manual it helps fill in the blanks.

Hello all! Looking for a 350 starter if anyone has one laying around?

Hello all, my half rings are in sad shape on my 84 k2. However the earlier half rings won’t work with the later K2 exhaust. Anyone have a solution/part number?

If anyone has this could you send it to my email?

What jetting did you use for your Mikunis? Looks good!

Specifically looking for swingarm pivot and wheel axle torques. I've never seen these quoted but again as John says above it won't be that critical to get an exact torque value. I normally use the appropriate size socket and a 1/2" drive ratchet or T-bar. (you ought not really be using a ratch...

Awesome, this is some good information. I’m not a part of Facebook but is there a way to get that service manual otherwise? Also I’m hanging trouble on that Rome site accessing the specific parts manual. Hi R1100, I've sent you a message about my K2 owners manual. Fiona Sydney, Australia Hello! I’m...