MRC Forum- brought to you by www.morini-riders-club.com

Well i finally got some free time to look at the bike.Mark you where right there were cracks in the pickup casing with the addition of heavy gouging to its inner surface caused by the magnet breaking up as it span by! Reckon its bust. As the old saying goes, if you've got a carb problem start by loo...

Thanks folk for the help and advice, I'm confident there are no air leaks. Even though I removed all the gasket cement some animal had used when fitting the carb rubbers, so much it was dripping into the carb throat ! (No none caused any blockages) And as the transducer ,plug and HT lead have proove...

NO foreign bodies in the inlet and the exhaust is clear.Slide has been checked and moves in time with its partner.
Must admit having had a nice fat spark I've not inspected the actual pickup got be worth a look for damage, although still baffled with the vacuum.

Bear with me I'll get to the point.It started with quick fettling of the carbs being needed due to poor running when pulling away on myX3 Kanguro. A thorough clean of the carbs carried out and all rubbers and seals are in good condition,slides are correct way round. But when started up she is reluct...

Thanks John, embarrised to say I was going about it all wrong settingup the clutch arm, but have it all set ok now. Though would still be interested to know correct length for the push rod, as I'm sure when Martin (Gelder) had the bike he mentioned something about there being a no. of different leng...

Hi folks little advise/info needed. Adjusting theclearance on the clutch activation arm in relation to the engine casing. When i get it to the required 15mm spacing as specified I'm left with somewhere near 5mm clearance between the arm and the end of push rod. I would presume this is a sign the clu...

Thanks for that Cosmo , bearing in mind what you've said I'll er on the side of caution I think and go for an extra few inches .

I've sourced an adaptor for the back of the speedo which converts from kph to mph, but it means I need a custom cable making up with jap sizing at the speedo end. As I've not got an original to work from could somebody please tell me the length of a Kanguro standard speedo cable ?

Hi folks, I'm hoping someone can help me I've inherited a Kanguro which I'm trying to refit the standard clocks and a few other parts. I've tried ringing Mdina Italia, but was basically told to go away and order on line unless I have the part numbers.From what I can see i would have to buy a book fr...