MRC Forum- brought to you by www.morini-riders-club.com

Cannot help, just curious... is it still stalling when slowing to trafic lights?

Just blocked the tube with a screw. Also took off the connector. Thats it. But of course I try to find a new one. The symptom was that it never closed when the motor was running. and made a weird rattle noise in the middle of calibration when turning off the ignition . And the shoots of course. Why ...

Mine 9 1/2 had also stalling problem. But it was kind of strange, because it was only temporary. Sometimes it was good and sometimes it stalled. I had also two exhaust valves 0,1 mm clearances. After adjusting it hasn't stalled. So, in my opinion, it could be the valve clearances. Mine also shoots i...

Hey! I have some problems with rough running in my 9 1/2. You can read about it in Corsaro topic. I have Tune ecu diagnos program. It shows various fault codes. When inspecting vehicle I noticed that fuel pump relay and nearly all other relays get very hot. Also voltage regulator is quite hot. (volt...

I'm sorry about waking up so old thread. But there were two bikes with problem and no proper answer. About the stepper motor... Yes, I have doubts about it because it makes weird rattling noise when shutting down the engine. Also it doesn't close at all even in higher rews. But the bike has run quit...

It Has been ok before. No perfect, but very relaxing ride. Now it's annoying when you ride any longer trips.

I have the same symptoms than Rrey used to have. Mine is 9 1/2. Has anyone solved this kind of problem?

Hello! My 2009 9 1/2 has ordinary spoke wheels. I´m a second owner, and I found inner tubes in both tyres. My mechanic also says there`s no such thing as a spoke wheels with tubeles. The user manual says they are tubeless style. What´s the truth? And if they are tubeless, do they work as they should?

Hi, Runner. It's nice to see, that there's an active Morinist in my homeland too. About the cam chain... I just adjusted my 9 1/2 valve clearances at 44 000 km. I guess it was the first time for that motor:( It had a stalling problem, but it fade away at once after the work. I also checked the chain...

Hey! I have had temporarily stalling problem. It's been mostly in wet conditions, but always got better sooner or later. In the same time the motor got running some kind of rough. Now it didn't cure by itself, so I opened the airbox. There was quite a lot of dirt inside. Cleaned it and oiled the air...

Thank you for your reply, Paul. Just planning the panniers

Hey! I'm a new member. Changed from Kawasaki for 9 1/2 last summer. The bike is 2009 and ridden 40 000 km. I l ive in Finland. Never seen another Morinis here, but I know there's a couple of Corsaros here. I really like the bike, because it's so relaxing to ride, but at the same time it can also be ...