MRC Forum- brought to you by www.morini-riders-club.com

Hello, "Eau de Morini" is unfortunately inevitable :D Today I got my '07 Corsaro back after a long time. A TPS cable was broken and also the speedo had to replaced. I would like to upload a proper mapping. My current setup is: stock exhaust with lambda + cat and GPR slipon with db killer. ...

Hi Fellas! I would like to kindly ask for advice regarding unknow electric issues with my '07 Corsaro 1200. Current setup: After 2 years of break I could purchase a new dashboard to revive my bike (highfive to Alberto, Morini spare parts manager). After installation it seemed that the Lambda sensor ...

HI The codes your system have thrown up relate to problems with A throttle position sensor {tps} or the wiring related to the tps or B the mods on your clocks ie the immobiliser problem you had also the last code is can bus wiring fault Check all your connections lube them with dielectric grease I ...

Previously went through all these steps.

Finaly i returned to JPdiag instead of GuzziDiag. Here is the result! Any idea What does it mean?

As I'm surfing on the forum I've found similar problems like mine but not the same: - throttle body's "holes" fulfilled: Could you explain more detailed where I should look for? - water in fuel system: Wynns dry fuel isn't available at my place anything else like this liquid? Injection cle...

Dear Fellow Riders! Just like couple times before I'm asking for your advice with my poor english :) Hopefully you have an idea to my strange issue with my Corsaro '07... Previously i was able to run with 8-8,5L/100km (ebisultimaterace05, open exh, decat, db killer in, no O2 sensor), relatively rare...

Hi eMGe, Mapping: 1) Did you perform tps reset? 2) Is everything else OK? I mean valve clearance, throttles synced, sparkplugs and batterie 100%? This should be checked first. If above is OK, it should run (and keep running) with CORA, CORC and Ebi's maps, with lambda off. Dashboard: MAE (the manuf...

Edit: Something went wrong with my previous post, sorry... Deleted

Hey Torquelovers! I'm already asked you about stock ecu's remap which I've done on my bike but it stills stalling. I uploaded erpis_racemap by guzzidiag and iaw writer. (I'm not sure in the map's name sorry, but that's the finest road use open loop map) Things got better but far from ideal. My spec ...

Thanks for the Information.

Finally i found the real reason...

Clutch slave cylinder's flatpush thingy was cracked invisibly... That was the reason of the slipping and air bubbles as well.

Obero, performance slave cyli,der solved the problem.

Hi! Previously i asked you about rich running of my Corsaro and finally problm solved by ebi's race map uploaded into my ecu. thanks. Actually i lookin for some help about clutch wearing on my 2007 Corsaro. I'm the 2nd owner, ride has 16500 km and my clutch seems slipping under pressure (various RPM...

Thank you so much. Tomorrow i'm gonna give a try than report the result. edit: Im just tried the writer thingy but can't read none of the maps which i have (*.ddg,*.ecm), it says http://kepfeltoltes.hu/130919/30437504612_www.kepfeltoltes.hu_.jpg . Btw in theright side of the total commander you can ...

Hey! First of all i must say sorry because of my english, but i hope you will understand what i mean. So i'm just bought a used Corsaro (2007). It has GPR slip-ons, cat eliminated, but i've got the original exhaust as well. Actually the bike starts hard, consumes 9-12 liter/100km, smells like open b...