Clutch pushrod
Posted: 15 Oct 2020 17:51
Investigating a slight weep of oil on this Coguaro around the right engine side. Not the crank seal. I replaced the gear selector oil seal a few weeks ago.The oil may be coming out via the pushrod seal, then running down over the neutral switch and back and under the rear cases, I removed the clutch arm and pulled out the short pushrod ( approx 29.8mm long by 6.96 mm diameter on this one) and the small oil seal ( 14 mm od 4 mm thick ?7mm I’d) The ends of the pushrod are not bad but along its length is somewhat scored and chewed. Do not know how or why? Seems a bit odd though.Wonder about the inner bore.
Can anyone confirm this short rod size or part number. I will try and source a replacement and seal.
If it’s not one thing it’s another.....
John
Can anyone confirm this short rod size or part number. I will try and source a replacement and seal.
If it’s not one thing it’s another.....
John