SOLD: First series Gaskets (base and head)- clear out

Morini related only please
Post Reply
mbmm350s
Posts: 666
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

SOLD: First series Gaskets (base and head)- clear out

Post by mbmm350s »

NOS 1st series gaskets, fibre with copper fire ring on the head gasket , only for use with stepped liners as in picture.
62mm for 350 up to 1979

13 pounds including UK postage.

The cognoscenti always check the lower gasket of original machines. :wink:
gaskets_orig.jpg
gaskets_orig.jpg (176.24 KiB) Viewed 4308 times
barell.jpg
barell.jpg (137.96 KiB) Viewed 4308 times
I have also one 66mm fibre head gasket - free just pay postage.

Mark
Last edited by mbmm350s on 14 Oct 2020 13:52, edited 1 time in total.
Stubaker58
Posts: 72
Joined: 28 Apr 2019 21:02
Location: Felixstowe, Suffolk

Re: First series Gaskets (base and head)- clear out

Post by Stubaker58 »

Hi Mark,
I’d be interested in the gaskets. PM sent
mbmm350s
Posts: 666
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: First series Gaskets (base and head)- clear out

Post by mbmm350s »

Stuart,

PM sent, do you still want?
Thanks
Mark
bizzywizzy
Posts: 61
Joined: 13 Jun 2019 21:00
Location: Cobham, Surrey, UK
Location: Cobham, Surrey, UK

Re: First series Gaskets (base and head)- clear out

Post by bizzywizzy »

If Stuart doesn’t want them I would like them.

Mike
Stubaker58
Posts: 72
Joined: 28 Apr 2019 21:02
Location: Felixstowe, Suffolk

Re: First series Gaskets (base and head)- clear out

Post by Stubaker58 »

Hi,
I’m not sure they are right for my bike (it’s a’79) so you take them.
Regards,
Stuart
mbmm350s
Posts: 666
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: First series Gaskets (base and head)- clear out

Post by mbmm350s »

Thanks Stuart,

The factory changed to the aluminium gaskets around 79.
This would be about the time of 350 electric start introduction and other engine changes
The blue manual published 1979 I think, clearly shows aluminium gaskets being used.
and in use on earlier engines, which is fine, if you use the sealant.
Athena list the gasket 1974-1978.
http://www.athenaparts.com/eng/products ... ead-gasket

I have 2 engines of the 14XXX range that are from 78 with the stepped liner.

Mark
mbmm350s
Posts: 666
Joined: 22 Jun 2018 10:18
Location: Reading UK
Location: Berkshire UK

Re: First series Gaskets (base and head)- clear out

Post by mbmm350s »

Mike PM sent
Mark
bizzywizzy
Posts: 61
Joined: 13 Jun 2019 21:00
Location: Cobham, Surrey, UK
Location: Cobham, Surrey, UK

Re: First series Gaskets (base and head)- clear out

Post by bizzywizzy »

mbmm350s wrote:Mike PM sent
Mark

Hi Mark,

I replied earlier.

Mike
Post Reply