Page 1 of 1

Imperial Milano

Posted: 13 Jan 2022 14:43
by MickeyMoto
On my trip to the SRS the plug on the front down pipe parted company on the M90. A trip to Halfrauds and a piece of aluminium and a jubilee clip fixed the blowing. I have been trying to figure out the thread and took out the rear one. After a bit of measuring and a trawl through t'interweb I bought a brass replacement.

Thread is, wait for it, 1/8" BSP... :) Easily obtained as used on lots of things...

I'll buy a few as spares!

Re: Imperial Milano

Posted: 13 Jan 2022 16:41
by mbmm350s
Bet you never expected to be nipping out to the "Plumb Centre" for Morini spares. :lol:

Re: Imperial Milano

Posted: 13 Jan 2022 17:42
by MickeyMoto
No! Apparently the Italians use the 1/8" bsp in toilet cisterns!

No more comments, please!

Re: Imperial Milano

Posted: 17 Jan 2022 14:23
by mbmm350s
Serious comment Mike, if its the same as mine, if you mean the one in the front pipe right at the bottom, has drillings for lockwire, not sure what one could wire it too though.
Cheers Mark

Re: Imperial Milano

Posted: 17 Jan 2022 18:32
by MickeyMoto
Mine didn't! :) you could tie it to the lambda sensor.