Hi I have some nice new seals to fit to my forks but can't figure out which way up... Two seals per leg from MDina but all seals have a lip, so is it bottom one lip down top one lip up? Or both the same way? Thanks for any pointers or even Bad Manners jokes..
Kevin
Fork seal orientation
-
- Posts: 450
- Joined: 16 Jun 2007 09:43
- Location: Northampton
Re: Fork seal orientation
Hi,
With the 2 per leg set up, both go in springs inside/down. Make sure that there is plenty of oil between the seals when refitting the stanchion so that the outer seal doesn't run dry.
I have a set of later forks that use 344210 fork seals that are designed to slide as opposed to seal a rotating shafts. Same thing- springs inside. These came with an aluminium washer underneath to fill the gap.
Regards,
George
With the 2 per leg set up, both go in springs inside/down. Make sure that there is plenty of oil between the seals when refitting the stanchion so that the outer seal doesn't run dry.
I have a set of later forks that use 344210 fork seals that are designed to slide as opposed to seal a rotating shafts. Same thing- springs inside. These came with an aluminium washer underneath to fill the gap.
Regards,
George
George
350 sport 1978, 350 Strada 1978
650 Norton 1967, 650 Kawasaki 1977 and 650 Enfield 2019
350 sport 1978, 350 Strada 1978
650 Norton 1967, 650 Kawasaki 1977 and 650 Enfield 2019