2C gasket l/h side/ clutch cover

250 2c- the Wee-WeeVees

2C gasket l/h side/ clutch cover

Postby Kmac » 26 Jul 2020 10:22

I need to free the clutch plates after not being used for awhile. Would anybody know if the gasket l/h side/ clutch cover is the same size as the 350.
Kmac
 
Posts: 12
Joined: 07 Jul 2020 20:08

Re: 2C gasket l/h side/ clutch cover

Postby mbmm350s » 26 Jul 2020 19:57

It's the same part 21.01.58 I can double check the cases tomorrow but I am sure it's the same.
Mark
mbmm350s
 
Posts: 290
Joined: 22 Jun 2018 10:18
Location: Berkshire UK

Re: 2C gasket l/h side/ clutch cover

Postby Kmac » 27 Jul 2020 18:23

Thanks Mark
Kmac
 
Posts: 12
Joined: 07 Jul 2020 20:08

Re: 2C gasket l/h side/ clutch cover

Postby EVguru » 28 Jul 2020 22:05

Start the engine, paddle the bike along as fast as you can and snick it into first gear, then pull in the clutch.

Always worked for me on wet clutch Morinis.

It also worked to free the clutch on my Yamaha GTS1000 after it had stood for several years, although you couldn't paddle that up to speed, it needed two people pushing.
Paul Compton
http://www.morini-mania.co.uk
http://www.youtube.com/user/EVguru
EVguru
 
Posts: 1455
Joined: 01 Aug 2006 11:13
Location: Luton

Re: 2C gasket l/h side/ clutch cover

Postby Kmac » 29 Jul 2020 18:11

Thanks Paul, I will give it a go tomorrow.
Keefe
Kmac
 
Posts: 12
Joined: 07 Jul 2020 20:08

? Not a chance

Postby George 350 » 29 Jul 2020 22:06

DON'T TRY THIS AT HOME!
Shouldn't admit this, but I had a Kawasaki GPZ1100 1981 model - Had stood for 3 years when I got it in 1985 as a non runner. Was young and ignorant then. Having sorted the 'non-running bit, the clutch wouldn't disengage so I put front wheel against side of house, held front brake on, revved to 6000rpm and stomped onto gear lever. Gravel peppered neighbours house as the rear tyre spun, then there was a big 'bang' from the clutch. And I 'got away with it! Plates had freed off and I subsequently used the bike for 5 years without any issues at all. Was still ok when I sold it.
Do that again? Not a chance.
Regards,
George
George
350 sport 1978, 350 Strada 1978
650 Norton and 650 Enfield
George 350
 
Posts: 365
Joined: 16 Jun 2007 09:43
Location: Northampton

Re: 2C gasket l/h side/ clutch cover

Postby Kmac » 30 Jul 2020 14:42

Clutch is free now, thanks for the advice.
Keefe
Kmac
 
Posts: 12
Joined: 07 Jul 2020 20:08


Return to 250 Vee

Who is online

Users browsing this forum: No registered users and 1 guest

cron