125 2T

[Arthur Farrow]

Ahhhhhhh....the manual is actually 5.5MB so should be e mailable.

Send request for one by e mail to arthurwfarrow@hotmail.com

[Krissyb]

Thanks mate I’ll be in touch

[Krissyb]

Just a little update, wheels not fully stripped and we’ve started to plate some of the parts.

I’ll be sure to pop some more pics up soon.

[Arthur Farrow]

Oh that looks posh

I would have masked off the spindle areas where they cannot be seen/go through bearings to ensure you do not get minor interference.

[Krissyb]

Let’s hope they still fit.

Thanks Kris

[Dave Cee]

Oh they will fit 100%

Only nickel plated them for 45 mins so not too many microns on them.
Little tickle on the lathe with some emery if needed

[Dave Cee]

Ok test for amount of nickel plating time so as not to cause an issue with the nipple threads being too tight on the spokes.

A 40 min plate for both spoke and nipple @ 700ma. All was good

IMG_1388.JPG (417.1 KiB) Viewed 289 times

IMG_1395.JPG (318.63 KiB) Viewed 289 times

IMG_1389.JPG (443.74 KiB) Viewed 289 times

[Dave Cee]

IMG_1394.JPG (343.44 KiB) Viewed 289 times

[Krissyb]

Good work Dave