MRC Forum- brought to you by www.morini-riders-club.com

1979 Moto Morini 125H, in black, with red pinstripe colour scheme and 24,182 Km recorded. Acquired by me in 2006 and then dry stored/refurbished until 2015 when the bike was MoT'd and used sparingly! MoT'd again in 2016 and has only covered 104Km since and been dry stored with a drained fuel tank an...

Aye Tom,

Thank you for the postage. Package despatched, just now. Please let me know of safe arrival.

My regards, Bill

Aye Tom, I was going to send you a PM, but have used PayPal, so hope it all works, I'm a bit of a 'Luddite' until I get used to this stuff! :wink: As for the football? :roll: Rugby is my preference, but a win for Scotland, in any sport is always welcome. :D :D MickeyMoto understands, even though I'm...

Aye Tom,

Not a problem to send them to the Netherlands, as long as you pay for the postage.

Royal Mail are charging £5-15 or ~Euro 6-60 at the present conversion rate.

Any use?

Thank you for your enquiry.

My regards, Bill

Aye, any takers of the following 'A Tutto Gas' back numbers afore they get re-cycled? Numbers 277, 278, 279, 280, 282, 284, 286 and 287. All are in good clean readable condition. Postage & packing: 2nd Class Royal Mail, alternatives available if requested at P&P cost to you. Free pick-up ava...

Aye Paul,
Thank you for your very generous offer of assistance, I have PM'd you.

My regards, Bill

Good evening, Having removed the flywheel and stator plate to renew the cam belt and put it altogether, I thought that I might have the timing incorrectly set and that this would account for the lack of performance above 60Kph in 6th gear, as described in my previous opening message thread. I invest...

Aye Andre,
Thank you for your offer. However, after fitting a new set of fibre plates and a half fibre plate the 'slip' appears to have been cured.
My regards, Bill.

Aye Mark and Paul, Thank you both for your comments and advice. I must rectify a couple of errors I made with the dimensions I gave in my initial post. The length of the springs in the clutch are 34.0mm not the 33.15mm quoted and the plain steel clutch plates are 1.2mm thick, not the 1.8mm quoted. :...

Gentlemen, Purchased a 125H in 2006 that then 'sat' until earlier this year. 23,000Km on the clock and doesn't appear to have been thrashed or dropped, so far! I've had the forks chromed by HCP, paint attacked on tank and mudguards by 'metal worm', so refinished with 2 pack and red stripes applied a...

Aye Johan,

Will send scans to your email address, hope this is OK.

My regards, themoudie

Aye Johan, I have a 125H with a frame number *4986*. It was a grey import into the UK and was declared as being manufactured in 1979, if that is of any help to you. I too have the same numbered plate pop riveted to the front right hand frame down tube. Hope this helps. My regards, themoudie. Google ...