MRC Forum- brought to you by www.morini-riders-club.com

Sorted.

Prototype... Surely 50% off.

My mistake they are 80mm outer diameter. Auxiliary lights from.. https://www.bikevis.com/product/bikevis-cree-motorcycle-auxiliary-lights/ Bracket off fleabay, initially for a cruiser type bike. Flip it 180° to fit, no huge mods needed other than I had to bend the tangs & fit smaller clamps to t...

Hi.
Purchased mine from AliExpress, but fleabay & Wish
sell them too. Now come in different colours. Amber would look even better imo.
Example...

Well not the real McCoy, but close enough. They are very bright, but not eye blindingly so. Wired up via the front auxiliary light with built in resistors. If I remember correctly they are 90mm diameter & sit just inside the headlight shroud & then clear siliconed into place. You have to tak...

Hi... Only the lever on the handlebar adjustment. Is the fluid in the clutch master cylinder discoloured? Sure sign of moisture ingress & a change of fluid + the rubber seals need replacing on the banjo bolt. Done mine twice now & then i purchased an Oberon slave cylinder (yet to be fitted) ...

Yarp.... I'm still interested.
Subject to design & pics.

It's been a while.
Any more news regarding engine bars?

Hi Ogri I have just had a dig around, you might have a thermostat malfunction, its staying closed and not allowing the full flow and consequently the correct fluid level /amount, there is a coolant sensor on the body which will still give you a temp reading but will shut the engine down if it gets ...

MysterG wrote: ↑08 Oct 2023 20:55 20231007_152730.jpg

Holy sh@t

Glad you are OK. Another reason why my faith in this bike is totally shattered. I don't use mine at all after lengthy intermittent problems. Only recently I've done a radiator flush & refill. This came about when checking the coolant level in the rad, only to find about a litre in there & ab...

Sounds promising.

Thank you.

Anyone fitted them to the Passo?
Trying to find front & rear sliders with spindles.
Rear is 33cm, front is 26cm length of spindle.
Not sure about inner axle hole diameter.
Wondering if the Corsaro are the same sizes?
Cheers.

Og's.

Hi all gp owners , I have found a company that is able to fabricate engine protection bars for my gp, it is quite expensive for just one set however if I can find at least another 4 orders it'll bring it down to a couple of hundred each is this something that others would be interested in please re...