MRC Forum- brought to you by www.morini-riders-club.com

Steve Brown: a very delayed reply. Thanks for your help, very useful indeed. I threw the choke cable away (seals were utterly knackered - good shout), and took the choke lever off it now has the carb chokes on each carb. I stripped and sonic cleaned the carbs, and due to previous poorly repaired dam...

Stempy: I just had a good chat with Dave at JJCables, I am going to send him my cable that he is going to take the upper ferrule off that and graft it onto a new cable for me, £23!! get in! Apparently, they'll do their best to make any cable for any bike! But they can't get bent Italian ferrules :) ...

Hello folks. Went for the shakedown run on the 500 to the Bell yesterday, with George. It was good to meet up with all of you by the way. The one proper failure that I did have on the way back, was the speedometer cable. It's gone to speedo' cable heaven. The one on the Mdina Italia site does not ap...

Thanks for the replies chaps, very helpful. To be honest Dave, I had presumed that the front tap was a small electrical fuel pump/fuel tap. I have just found a thread posted on the board about replacing this tap with an MZ ETZ manual tap. Does anyone know what other, if any, manual fuel taps can be ...

Here's a thing chaps, what happens if you need one, but there aren't any? What alternatives are there?

J

I have a problem with my SEI, it will accelerate so far and the it just goes "bwarrrrrr" and bogs down, before eventually clearing. It never seems to run clean from then on though, it feels restricted. The bike is equipped with Dellorto PHBH26 BS carburettors. The main jet is 120: the idel...

Has anyone any idea where I could get hold of a couple of new nylon fork bushese for this item (35mm Marzzochi's), or indeed any spares for these forks? The bushes are serviceable, but whilst the forks are apart having new fork seals and a service I thought I might try to improve matters! Any (sensi...

Thanks Mark. I just had a look they do not appear to have the bits, however my Italian is not great!!

Has anyone any idea where I could get hold of a couple of new nylon fork bushese for this item (35mm Marzzochi's), or indeed any spares for these forks? The bushes are serviceable, but whilst the forks are apart having new fork seals and a service I thought I might try to improve matters! Any (sensi...

Has anyone any idea where I could get hold of a couple of new nylon fork bushese for this item (35mm Marzzochi's), or indeed any spares for these forks? The bushes are serviceable, but whilst the forks are apart having new fork seals and a service I thought I might try to improve matters! Any (sensi...

Folks: if anyone is interested my son has just printed me an mph bezel on his 3d printer. It doesn't look half bad, quite smart. Unfortunately I cannot upload an image, because my "...board attachment quota...", has been reached, apparently! However message me and I'll send you a picture o...

Mike - found the user control panel and messages etc., but I don't have one from you.
Thanks
Jack

Mike,
can you please tell me where I might find it, I genuinely do not have a clue!
Thanks
Jack

Folks - I've sorted the centre-stand thanks.
Jack

Hello MIckey.
It was me who needed one. Perfectly reasonable price. I'll take it off your hands.

Bank transfer? I don't know if you can send me a private message through the site.
If not we'll need to sort something out.

Cheers
Jack